LPAR1 is configured to have the same 2 LUNs virtualized by a redundant pair of VIO servers. Which command will validate thatboth storage paths are available?()
第1题:
A.When properly configured,VTP minimizes VLAN misconfigurations and configuration inconsistencies
B.Each broadcast domain on a switch can have its own unique VTP domain
C.VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.
D.When properly configured,VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.
E.VTP pruning is used to increase available bandwidth in trunk links
F.Client,server,and transparent are valid VTP modes
G. To configure a switch to be part of two VTP domains,each domain must have its own passwords
第2题:
Which of the following are true about SSIDs configured in the ADU?()
第3题:
LPAR1 is configured to have the same 2 LUNs virtualized by a redundant pair of VIO servers. Which command will validate that both storage paths are available?()
第4题:
You are designing a remote administration solution that meets business requirements. You need to specify client or server software that will be required. What should you do?()
第5题:
SSIDs are not case sensitive.
SSIDs must be listed in the same order in the ADU as they are in the access point.
A maximum of three SSIDs may be configured.
SSIDs may have a maximum of 16 characters.
第6题:
2
3
4
7
第7题:
When properly configured,VTP minimizes VLAN misconfigurations and configuration inconsistencies
Each broadcast domain on a switch can have its own unique VTP domain
VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.
When properly configured,VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.
VTP pruning is used to increase available bandwidth in trunk links
Client,server,and transparent are valid VTP modes
To configure a switch to be part of two VTP domains,each domain must have its own passwords
第8题:
AutoOoS can be implemented on only one side of a link.
The interface does not have to have an IP address associated with it.
The AutoOoS feature cannot be configured on a Frame Relay DLCI if a map class is attached to the DLCI.
In a Frame Relay network, AutoOoS cannot be configured if a DLCI is already assigned to the Frame Relay subinterface
第9题:
best effort (BE)
network control (NC)
assured forwarding (AF)
expedited forwarding (EF)
第10题:
IBSS
BSS
ESS
SSID
第11题:
Which two statements are correct about configuring AutoQoS on a Cisco router? ()
第12题:
For a router to successfully redistribute routes between OSPF and EIGRP, which of the following are true?()
第13题:
Which of the following is required to ensure the completion of all tests within the automated procedure of thecluster test tool?()
第14题:
The interface is not plumbed.
The interface is not configured.
The interface does not have valid routes configured.
The interface is not marked as
第15题:
It is a route to be used when the routing protocol fails.
It is a route configured by an ISP that sends traffic into a corporate network.
It is a route used when a packet is destined for a remote network that is not listed in the routing table.
It is a route manually configured for a specific remote network for which a routing protocol is not configured.
It is used to send traffic to a stub network.
第16题:
ssids are not case-sensitive.
ssids must be listed in the same order in the adu as they are in the access point.
a maximum of three ssids may be configured.
ssids may have a maximum of 16 characters.
第17题:
Edit the /etc/netsvc.conf file to have a nameserver and a domain search order.
Edit the /etc/resolv.conf file to have a nameserver and a domain search order.
Edit the /etc/resolv.conf file to have a nameserver, domain, and domain search order.
Edit the /etc/netsvc.conf file to have a nameserver, domain, and domain search order.
第18题:
duplex mismatch
a routing loop
trunking mode mismatch
improperly configured root bridge
improperly configured static VLAN
第19题:
Server configured with the Client Access server role.
Server configured with the Hub Transport role.
Server configured with the Mailbox role.
Server configured with the Unified Messaging server role.