The associated VLANs of a vNIC are not found on an uplink.
Overlapping VLAN IDs exist on upstream disjoint networks.
The vNIC was not configured for fabric failover.
The vNIC is pinned to the wrong fabric.
Overlapping VSAN IDs exist on upstream SAN switches.
The vHBA was not configured for failover.
第1题:
You are responsible for network monitoring and need to monitor traffic over a routed network from a remote source to an IDS or IPS located in the headquarters site. What would you use in order to accomplish this?()
第2题:
The network is displayed in the diagram below: You use the following information for switch SWA: Port Mode Encapsulation Status Native VLAN fa0/1 desirable n-802.1q trunking 5 Port VLANs is allowed on trunk fa0/ 1 1-100, 102-1005 Port VLANs is owned and active in management domain fa0/1 1-6. 8-100, 102-115, 197-999, 1002-1005 Port VLANs in spanning tree forwarding state and not pruned fa0/1 1-6, 8-100, 102-105, 108-999, 1002-1005 SW users in VLAN 107 complain that they are unable to gain access to the resources through theSW1 router. What is the cause of this problem?()
第3题:
What would be the cause for the following fault in UCS Manager?() "ether VIF x / xxx down, reason: ENM source pinning failed"
第4题:
Before inserting a new switch in the network,the network administrator checks that the VTP domain name is correct,the VTP mode is set to server, and revision is lower than the switches in the network. The administrator then configures interfaces and trunks,erases existing VLANs,and connects the switch to the network. Following that procedure,there is no connectivity in the network. What is a possible cause of this problem?()
第5题:
While discussing the specifications of replacement servers, the administrator’s manager asks what can be done to avoid the down time associated with failed hard drives on the servers. Which of the following should the administrator recommend?()
第6题:
Mirror all disks to avoid replacement
Purchase servers with hot swappable drives configured in a RAID
Purchase servers with duplicate drives configured as RAID 0
Perform timely backups
第7题:
Remove second NIC from each port profile
Remove VEM from VSM (no vem X), remove NICs, and reinsert
Ensure that VLANs on uplink profiles are not overlapping
Reinstall VEM
Issue the command module vem X execute vemcmd set pinning module vsm 1
第8题:
Speed mismatch
Incorrect encapsulation
MTU set too low
Duplex mismatch
第9题:
The fabric interconnect is in the end-host mode, and all uplink ports have failed.
The server port to which the adapter is pinned has failed.
A transient error has caused the link to fail.
The fabric interconnect is in the switch mode, and all uplink ports have failed.
The link for a network-facing host interface is missing.
第10题:
Check the printers error log, and then inform the primary user what the issue is.
Go directly to the printer and investigate any issues that are found.
Investigate the printers status, then ask the primary user to write down what they think is wrong.
Gather information from the primary user, and then evaluate the printers condition.
第11题:
between the radius and the access point
between the client’s vlan and the wlse
between the native vlan and the wlse
between the client’s vlan and the radius
第12题:
VACLs and VSPAN
RSPAN
ERSPAN
NetFlow
第13题:
Which statement ab0ut VLANs in a Cisco UCS is true?()
第14题:
A user has no network connectivity. A check of the associated port indicates that the interface is up, the line protocol is down. Which item would most likely cause this problem?()
第15题:
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager? ()
第16题:
An 802.1X client cannot authenticate to an autonomous access point configured for multiple VLANs. The native VLAN does not have an SSID configured. Which one of the following links being down would prevent the clients from authenticating?()
第17题:
Because the configuration revision of the new switches is lower than the rest of the network, it can change the VLAN database of the other switches.
As a VTP server, the new switch deleted all VLANs of the network.
Erasing VLANs increases the VTP configuration revision.
Since the configuration revision of the network is higher than the new switch, the VLAN database was automatically synchronized.
第18题:
between the RADIUS and the access point
between the client’s VLAN and the WLSE
between the native VLAN and the WLSE
between the client’s VLAN and the RADIUS
第19题:
module vem X execute vemcmd show trunk
show module 3 internal pinning
module vem X execute vemcmd show port
show module vem mapping
show interface vethX pinning
第20题:
802.1q tunneling
ATM
SDH
IP Over Optical Networking
ISL
第21题:
VLAN 107 is not configured on the trunk
VLAN 107 does not exist on switch SWA
VTP is pruning VLAN 107
Spanning tree is not enabled on VLAN 107
None of the other alternatives apply
第22题:
Fabric interconnect can never participate in VTP
Fabric interconnect supports ISL and 802.1Q trunking
The supported range of VLANs is auto-configured by UCS
VLANs are configured through the Cisco UCS manager. (fabric interconnect may be set up in switch mode)
第23题:
A failed RAID controller
Two failed processors
Two failed sticks of memory
Two failed drives