you can apply multiple access lists with the same protocol or in different direction.
you can config one access list,per direction,per layer 3 protocol
you can place as many access lists as you want on any interface
you can apply only one access list on any interface
第1题:
Which of the following are characteristics of named access lists?()
第2题:
Which of the following statements regarding the use of multiple access lists are valid when configuring a single interface on a Cisco router?()
第3题:
Which statement is true about terms in a policy?()
第4题:
Which statement best describes configuring access control lists to control Telnet traffic destined to therouter itself?()
第5题:
Which statement regarding the site-survey process is correct?()
第6题:
Which statement about access lists that are applied to an interface is true?()
第7题:
Individual statements in a named access list may be deleted.
They require a numbered range from 1000 to 1099.
When created, they must be specified as standard or extended.
They are created with the ip access-list command.
The entire access list must be deleted before editing.
They are applied with the ip name-group command.
第8题:
The ACL applied to the vty lines has no in or out option like ACL being applied to an interface.
The ACL is applied to the Telnet port with the ip access-group command.
The ACL must be applied to each vty line individually.
The ACL should be applied to all vty lines in the in direction to prevent an unwanted user from connecting to an unsecured port.
第9题:
In a multifloor building, the access point layout from the survey of one floor can be directly applied to the remaining floors
Access points can be installed in the same place on every floor, without worrying about co-channelinterference
You can survey with a Cisco AIR-ANT5959 in a plenum environment
Identify all hazardous and restricted areas that might require extra or special survey and installationwork
第10题:
you can apply multiple access lists with the same protocol or in different direction.
you can config one access list,per direction,per layer 3 protocol
you can place as many access lists as you want on any interface
you can apply only one access list on any interface
第11题:
A single term can be applied to a protocol or interface, independent of the policy.
Once configured, terms within a policy cannot be reordered.
The name of a term is limited to five characters.
A from statement is optional in a term.
第12题:
The data traffic between the access point and controller is not encrypted.
The data traffic is encapsulated with LWAPP.
The data traffic is switched at the access point before being sent to the WLAN controller where VLAN tagging and QoS are applied.
The data traffic is encrypted with AES.
All of the above
第13题:
Which two statements about queuing mechanisms are true? ()
第14题:
Which statement is true about terms in a policy?()
第15题:
Which statement is true about the data traffic between the access point named TKAP1 and controller TKC1?()
第16题:
Which command shows if an access list is assigned to an interface?()
第17题:
Which statement about PPPoA configuration is correct?()
第18题:
Which statement is TRUE about the CacheFactory class ?()
第19题:
Application of up to three access lists per protocol to a single interface.
No more than two access lists per interface.
One access list may be configured per direction for each Layer 3 protocol configured on an interface.
The maximum number allowed varies due to RAM availability in the router.
An infinite number of access lists that can be applied to an interface, from most specific to most general.
Cisco IOS allows only one access list to an interface.
第20题:
FIFO queuing is only appropriate for slower serial interfaces
weighted fair queuing is the default queuing mechanism used for all but slower than E1 rate interfaces
only one queuing mechanism type can be applied to an interface
weighted fair queuing does not require the configuration of access lists to classify traffic
flow-based weighted fair queuing provides for queues to be serviced in a round-robin fashion
第21题:
you can apply multiple access lists with the same protocol or in different…
you can config one access list,per direction,per layer 3 protocol
you can placeasmanyaccess lists as you want on any interface
you can apply ony one access list on any interface
第22题:
Import policies concern routes received and determine which routes get put into the routing table.
Export policies concern routes received and determine which routes get put into the routing table.
Export policies are applied before the routing table.
Import polices are applied after the routing table.
第23题:
A single term can be applied to a protocol or interface, independent of the policy
Every policy must contain at least one term
The name of a term is limited to five characters
Terms are optional
第24题:
The dsl operating-mode auto command is required if the default mode has been changed
The ip mtu 1496 command must be applied on the dialer interface
The encapsulation ppp command is required
The ip mtu 1492 command must be applied on the dialer interface