6
7
8
9
第1题:
Which of the following is the number of SCSI devices that can be added to a single narrow SCSI bus?()
第2题:
Companycom is about to purchase a POWER5 Enterprise server which requires two Ethernet ports and two disks for each of the four LPARs. It has been configured and validated using the IBM eConfig tool. Which of the following is very important to verify in addition to the eConfig validation?()
第3题:
Which of the following internal storage technologies has the HIGHEST single drive storage capacity?()
第4题:
Which of the following MOST likely causes problems with SCSI communication?()
第5题:
An administrator is up grading the back up server from a single tape drive to a SCSI tape library. The library has been unpackaged, mounted, and the library drivers installed. Which of the following items should the administrator have to connect the device to the backup server?()
第6题:
The latest SCSI adaptor card is purchased from a vendor. Drivers for the operating system cannot be obtained. The SCSI adapter card is added to an existing server. Upon booting, the operating system does not detect the card. Which of the following is the MOST likely cause of the problem?()
第7题:
The SCSI card is not seated correctly.
The termination is incorrectly set on the SCSI card.
The SCSI card is not listed on the operating system HCL (Hardware Compatibility List).
Operating system patches were not updated before installing the card.
第8题:
Up to 25 m bus length
Only one device per SCSI bus
Up to 16 devices per SCSI bus
Half-duplex operation
Full-duplex operation
第9题:
The bus is limited to 64 devices.
It is a full-duplex serial standard.
It is a half-duplex serial standard.
It allows up to 320 MB/s of shared channel bandwidth.
第10题:
JBOD
DAS
NAS
SAN
第11题:
SAS
SATA
Flash
SCSI
第12题:
Low communication latency
Maximum drive capacity is exceeded
Improper termination
Too many SCSI devices on one system
第13题:
Attaching to a SCSI storage system through redundant paths will provide which of the following?()
第14题:
What are the two parallel SCSI specifications?()
第15题:
A server in a manufacturing environment needs to receive input from multiple measurement devices on the production line. Which of the following would be needed on the server?()
第16题:
Which of the following is a storage system that can be connected to multiple servers through ani SCSI connection?()
第17题:
Which of the following bus types requires termination using a separate device?()
第18题:
Which command enables new devices that are connected to the scsi5 adapter without performing a full scan of the system?()
第19题:
Total number of SCSI adapters
Total number of Ethernet adapters
Total number of Ethernet adapters and number of SCSI paths per LPAR
Total number of SCSI paths available and total number of SCSI adapters
第20题:
6
7
8
9
第21题:
SCSI cable
SCSI interface adapter on the tape library
SCSI termination card on the server
iSCSI cable
第22题:
The ability to interleave writes to the array
High Availability and failover
LUN sharing via Target Mode SCSI on the storage system
A greater number of LUNS available on the same storage system
第23题:
Low communication latency
Maximum drive capacity is exceeded
Improper termination
Too many SCSI devices on one system
第24题:
cfgmgr -f scsi5
cfgmgr -i scsi5
cfgmgr -t scsi5
cfgmgr -l scsi5