The router receiving the route translates the Type 7 LSA into a Type 5 LSA.
The ABR with the lowest router ID translates all Type 7 LSAs into Type 5 LSAs.
The ABR with the highest router ID translates all Type 7 LSAs into Type 5 LSAs.
All ABRs translate the Type 7 LSAs into Type 5 LSAs depending on which one has the lowest cost to the route.
第1题:
A. All OSPF routers in stubby areas can have type 3 LSAs in their database.
B. All OSPF routers in stubby areas can have type 7 LSAs in their database.
C. All OSPF routers in totally stubby areas can have type 3 LSAs in their database.
D. All OSPF routers in totally stubby areas can have type 7 LSAs in their database.
E. All OSPF routers in NSSA areas can have type 3 LSAs in their database.
F. All OSPF routers in NSSA areas can have type 7 LSAs in their database.
第2题:
A.It is used for type 1 router LSA
B.Highest IP address of the loopback is used
C.router-id needs to be matched on ospf neighbors
D.router-id is 16 bit
第3题:
Which is true about OSPF router-id?()
第4题:
Which router is doing LSA type 7 to type 5 translation,and why?()
第5题:
Which statement best describes OSPF external LSAs (type 5)?()
第6题:
Which three statements about OSPF partial SPF are true?()
第7题:
Which router translates the Type 7 LSAs into Type 5 LSAs, according to RFC 1587 (OSPF NSSAOption) in an OSPF NSSA with more than one ABR?()
第8题:
Which LSA is used in JUNOS software when a OSPF router restarts?()
第9题:
show ip ospf database external
show ip ospf database nssa - external
show ip route ospf
show ip ospf datab ase summary
show ip route
第10题:
OSPF external LSAs are automatically flooded into all OSPF areas, unlike type 7 LSAs, which require that redistribution be configured.
External LSAs (type 5) are automatically changed to type 1 LSAs at ASBRs.
Type 5 LSAs are route summaries describing routes to networks outside the OSPF Autonomous System.
External network LSAs (type 5) redistributed from other routing protocols into OSPF are not permitted to flood into a stub area
第11题:
The router receiving the route translates the Type 7 LSA into a Type 5 LSA.
The ABR with the lowest router ID translates all Type 7 LSAs into Type 5 LSAs.
The ABR with the highest router ID translates all Type 7 LSAs into Type 5 LSAs.
All ABRs translate the Type 7 LSAs into Type 5 LSAs depending on which one has the lowest cost to the route.
第12题:
If it is triggered by Type 4, all Type 4 LSAs that announce a certain ASBR and all Type 5 and 7 LSAs are processed
If it is triggered by Types 5 and 7, all Type 5 and 7 LSAs that contribute to a certain destination are processed.
If it is triggered by Type 2, all Type 2 LSAs that contribute to a certain destination are processed.
If it is triggered by the change of Type 3, 4, 5, and 7 LSAs.
If it is triggered by the change of Type 2, 3, 5, and 7 LSAs
第13题:
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence.
第14题:
在NSSA区域有多个ABR时,并不是所有ABR都能把7类LSA转换成5类LSA的。因为按RFC1587:OSPFNSSAOption的规定,在NSSA区域有多个ABR时,只有最大的RouterID的ABR将type7LSA负责转换为type5LSA。
第15题:
What OSPF LSA is used to support MPLS-traffic Engineering ?()
第16题:
Which of the following are not true OSPF LSA rules?()
第17题:
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? ()
第18题:
Which show command will display only the Type 5 LSAs in the OSPF topology database?()
第19题:
You want to limit the number of Type 7 LSAs to be converted into Type 5 LSAs at an appropriateABR. Which two commands should you use from the [edit] hierarchy level within JUNOS configuration mode?()
第20题:
OSPFv3 interarea-prefix-LSAs are most similar to which OSPFv2 LSA type?()
第21题:
Both RTA and RTB will do LSA7/5 translation,since they are both NSSA ABRs
RTA will do LSA7/5 translation,since it has the lower router ID
RTB will do LSA7/5 translation,since it has the higher router ID
The redistributing router will do LSA7/5 translation,since it is within the NSSA
第22题:
The output lists nothing unless 10.100.0.0 has been configured as a summary rou te using the area range command.
If 10.100.0.0 is a subnet in area 0, the output lists one Type 3 LSA, specifically the LSA with the lower metric when comparing ABR1's and ABR2's LSA for 10.100.0.0.
If 10.100.0.0 is a subnet in area 0, the output lists two Type 3 LSAs, one each created by BR1 and ABR2.
None, because the Type 3 LSAs would exist only in the ABR's LSDBs.
第23题:
LSA Type 6
LSA Type 9
LSA Type 10
LSA Type 11
第24题:
OSPF LSA type 5 triggers an LSA type 7 at an ABR between an NSSA and the backbone area
OSPF LSA type 1 triggers an LSA type 3 at an ABR.
OSPF LSA type 7 triggers an LSA type 5 at an ABR between an NSSA and the backbone area
OSPF LSA type 3 triggers an LSA type 4 at an ABR.
OSPF LSA type 5 triggers an LSA type 7 at an A5BR but only in N5SAs
OSFP LSA type 2 triggers an LSA type 3 at an ABR