niusouti.com

单选题Which interface does the Infranet Controller use to push the configuration? （）A trusted portB internal portC trust interfaceD untrust interface

题目
单选题
Which interface does the Infranet Controller use to push the configuration? （）
A

trusted port

B

internal port

C

trust interface

D

untrust interface

相似考题

1.A customer is deploying a new Junos Pulse Access Control Service and has completed the initial boot configuration as prompted using a serial connection. The customer now wants to complete the rest of the configuration using the admin GUI.Into which port on the Junos Pulse Access Control Service should the customer plug the network cable to enable access to the admin GUI?（）A. the internal interfaceB. the external interfaceC. the management interfaceD. the console interface

2.When the Infranet Enforcer is set up in transparent mode, which additional resource policy must be configured to use OAC for IPsec enforcement? ()A. IPsec RoutingB. Access ControlC. IP Address PoolD. Source Interface

3.Which interface does the Infranet Controller use to push the configuration? ()A. trusted portB. internal portC. trust interfaceD. untrust interface

4.Which CLI command displays the IS－IS level used by each interface?()A. show clns neighborB. show isis neighborC. show clns interfaceD. show isis interface

更多“单选题Which interface does the Infranet Controller use to push the configuration? （）A trusted portB internal portC trust interfaceD untrust interface”相关问题

  • 第1题：

    To troubleshoot interface problems, you can use both the disable command and the deactivate command. Which two statements are correct?()

    A.If the interface is disabled, the logical unit will administratively shutdown.

    B.If the interface is deactivated, the physical interface will administratively shutdown.

    C.If the interface is deactivated, the interface configuration is ignored during commit.

    D.If the interface is disabled, the logical unit configuration is ignored during commit.


    参考答案：B, C

  • 第2题：

    A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port（）。

    • A、This is a 10 Mb/s switch port
    • B、This is a 100 Mb/s switch port
    • C、This is an Ethernet port operating at half duplex
    • D、This is an Ethernet port operating at full duplex
    • E、This is a port on a network interface card in a PC

    正确答案:C

  • 第3题：

    To protect the network from external and internal threats， where should Cisco IPS be enabled on an ISR？（）

    • A、Globally on the ISR
    • B、On the Console and Auxiliary Ports of the ISR
    • C、On the untrusted （Outside） interface of the ISR
    • D、On the trusted （Inside） interface of the ISR
    • E、On the WAN and LAN interfaces of the ISR

    正确答案:E

  • 第4题：

    You are using IPv6， and would like to configure EIGRPv3. Which three of these correctly describe how you can perform this configuration？（）

    • A、EIGRP for IPv6 is directly configured on the interfaces over which it runs.
    • B、EIGRP for IPv6 is not configured on the interfaces over which it runs， but if a user uses passive-interface configuration， EIGRP for IPv6 needs to be configured on the interface that is made passive.
    • C、There is a network statement configuration in EIGRP for IPv6， the same as for IPv4.
    • D、There is no network statement configuration in EIGRP for IPv6.
    • E、When a user uses a passive-interface configuration， EIGRP for IPv6 does not need to be configured on the interface that is made passive.
    • F、When a user uses a non-passive-interface configuration， EIGRP for IPv6 does not need to be configured on the interface that is made passive

    正确答案:A,D,E

  • 第5题：

    Which one of the following commands will display the placement and direction of an IP access control list on the interfaces of a router?（）

    • A、show interface list
    • B、show ip route
    • C、show ip interface
    • D、show ip interface brief
    • E、show interface

    正确答案:C

  • 第6题：

    Which interface does the Infranet Controller use to push the configuration? （）

    • A、trusted port
    • B、internal port
    • C、trust interface
    • D、untrust interface

    正确答案:B

  • 第7题：

    Which CLI command displays the IS-IS level used by each interface?（）

    • A、show clns neighbor
    • B、show isis neighbor
    • C、show clns interface
    • D、show isis interface

    正确答案:C

  • 第8题：

    多选题
    To troubleshoot interface problems, you can use both the disable command and the deactivate command. Which two statements are correct?（）
    A

    If the interface is disabled, the logical unit will administratively shutdown.

    B

    If the interface is deactivated, the physical interface will administratively shutdown.

    C

    If the interface is deactivated, the interface configuration is ignored during commit.

    D

    If the interface is disabled, the logical unit configuration is ignored during commit.


    正确答案： B,C
    解析： 暂无解析

  • 第9题：

    单选题
    You would like to configure a fractional T1 interface on a channelized T3 controller with the following properties: Which set of configuration commands accomplishes this goal?（）
    A

    A

    B

    B

    C

    C

    D

    D


    正确答案： D
    解析： 暂无解析

  • 第10题：

    单选题
    Click the Exhibit button. Based on the exhibit, client PC 192.168.10.10 cannot ping 1.1.1.2. Which is a potential cause for this problem?（）
    A

    The untrust zone does not have a management policy configured.

    B

    The trust zone does not have ping enabled as host-inbound-traffic service.

    C

    The security policy from the trust zone to the untrust zone does not permit ping.

    D

    No security policy exists for the ICMP reply packet from the untrust zone to the trust zone.


    正确答案： D
    解析： 暂无解析

  • 第11题：

    单选题
    Which operational command would you use to quickly verify the state of all interfaces?（）
    A

    show interfaces terse

    B

    show interfaces

    C

    show configuration interfaces

    D

    show interface status


    正确答案： B
    解析： 暂无解析

  • 第12题：

    单选题
    To protect the network from external and internal threats， where should Cisco IPS be enabled on an ISR？（）
    A

    Globally on the ISR

    B

    On the Console and Auxiliary Ports of the ISR

    C

    On the untrusted （Outside） interface of the ISR

    D

    On the trusted （Inside） interface of the ISR

    E

    On the WAN and LAN interfaces of the ISR


    正确答案： C
    解析： 暂无解析

  • 第13题：

    Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?（）

    A. PPP on the ATM interface

    B. VPI/VCI on the dialer interface

    C. IP address on the ATM interface

    D. CHAP on the dialer interface


    参考答案：D

  • 第14题：

    Which port role has interface Fa0/2 of switch 1 adopted for VLAN 47？（）

    • A、Root port
    • B、Nondesigned port
    • C、Designated port
    • D、Backup port
    • E、Alternate port
    • F、None of the other alternatives apply

    正确答案:C

  • 第15题：

    Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured. Which combinations accurately describe the interface under which a feature will be configured?（）

    • A、PPP on the ATM interface
    • B、VPI/VCI on the dialer interface
    • C、IP address on the ATM interface
    • D、CHAP on the dialer interface

    正确答案:D

  • 第16题：

    A customer is deploying a new Junos Pulse Access Control Service and has completed the initial boot configuration as prompted using a serial connection. The customer now wants to complete the rest of the configuration using the admin GUI.Into which port on the Junos Pulse Access Control Service should the customer plug the network cable to enable access to the admin GUI?（）

    • A、the internal interface
    • B、the external interface
    • C、the management interface
    • D、the console interface

    正确答案:A

  • 第17题：

    When configuring IOS firewall （CBAC） operations on Cisco routers， the "inspection rule" could be applied at which two locations？ （）

    • A、 at the untrusted interfacein the inbound direction
    • B、 atthe untrusted interface in theoutbounddirection
    • C、 at thetrusted interface inthe inbound direction
    • D、 at the trusted interface in the outbound direction
    • E、 at the trusted and untrusted interfaces in the inbound direction
    • F、 at the trusted and untrusted interfaces in the outbounddirection

    正确答案:B,C

  • 第18题：

    When the Infranet Enforcer is set up in transparent mode, which additional resource policy must be configured to use OAC for IPsec enforcement? （）

    • A、IPsec Routing
    • B、Access Control
    • C、IP Address Pool
    • D、Source Interface

    正确答案:D

  • 第19题：

    Which operational command would you use to quickly verify the state of all interfaces?（）

    • A、show interfaces terse
    • B、show interfaces
    • C、show configuration interfaces
    • D、show interface status

    正确答案:A

  • 第20题：

    单选题
    Which interface does the Infranet Controller use to push the configuration? （）
    A

    trusted port

    B

    internal port

    C

    trust interface

    D

    untrust interface


    正确答案： D
    解析： 暂无解析

  • 第21题：

    多选题
    When configuring IOS firewall （CBAC） operations on Cisco routers， the "inspection rule" could be applied at which two locations？ （）
    A

    at the untrusted interfacein the inbound direction

    B

    atthe untrusted interface in theoutbounddirection

    C

    at thetrusted interface inthe inbound direction

    D

    at the trusted interface in the outbound direction

    E

    at the trusted and untrusted interfaces in the inbound direction

    F

    at the trusted and untrusted interfaces in the outbounddirection


    正确答案： E,B
    解析： 暂无解析

  • 第22题：

    单选题
    Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured. Which combinations accurately describe the interface under which a feature will be configured?（）
    A

    PPP on the ATM interface

    B

    VPI/VCI on the dialer interface

    C

    IP address on the ATM interface

    D

    CHAP on the dialer interface


    正确答案： C
    解析： 暂无解析

  • 第23题：

    单选题
    Which configuration option can be set either in the initial console menu or the Admin UI of the Infranet Controller? （）
    A

    VLAN ID

    B

    Hostname

    C

    Domain name

    D

    Administrative timeout


    正确答案： C
    解析： 暂无解析

  • 第24题：

    单选题
    When the Infranet Enforcer is set up in transparent mode, which additional resource policy must be configured to use OAC for IPsec enforcement? （）
    A

    IPsec Routing

    B

    Access Control

    C

    IP Address Pool

    D

    Source Interface


    正确答案： B
    解析： 暂无解析

相关内容