0
1
255
256
第1题:
An administrator is creating a new logical partition (LPAR) with 6 virtual processors and 4 processing units. This LPAR must have the highest priority in the shared processor pool. Which weight should be assigned to this LPAR?()
第2题:
A POWER6 595 LPAR has two dedicated processors. The LPAR is active and running AIX 6.1. What must be done to donate any unusedprocessing capacity to the shared processor pool?()
第3题:
An administrator has installed 1 VIO Server and 5 client LPARs on a 16-core Power 570 with the following CPU requirements: Virtual Processors Processing Units Min Desired Max Min Desired Max VIOS1 1 2 4 0.1 1.0 2.0 LPAR1 4 4 4 4.0 4.0 4.0 LPAR2 2 5 8 1.0 5.0 6.0 LPAR3 1 3 4 0.1 0.3 1.0 LPAR4 3 6 9 0.5 3.0 6.0 LPAR5 1 3 6 1.0 3.0 .06 If the administrator activates the LPARs in the above order, what will be the result? ()
第4题:
Company.com has a 2 processor license for SLES 9 and a 2 processor license for AIX V5.3. Which of the following LPAR configurations is valid on a 4-way p5-550?()
第5题:
A customer would like to configure an uncapped LPAR so that it can use 2 to 8 cores depending on the workload characteristics. With SMT4 enabled, what is the least amount of processing resources which can be configured for the LPAR?()
第6题:
A graphics monitor must be attached to the server
Cluster System Management (CSM) software must be installed
The LPAR system must have an Hardware Management Console (HMC) connected
Each LPAR must be configured with a CDROM for operating system installation
第7题:
The uncapped weight has been set to 0.
The uncapped weight has been set to 128.
The processing unit for that partition was set to .1 processing units. A full processor was assigned.
The processing unit for that partition was set to 0.50 processing units. A full processor was assigned.
第8题:
Two HBAs assigned to each redundant VIOS which provides VSCSI access to LUNs
Two HBAs assigned to each LPAR with each LPAR owning HBAs on the same PCI busses
Two HBAs assigned to each LPAR with each LPAR owning HBAs on separate PCI busses
One HBA assigned to each LPAR and two HBAs assigned to a VIOS providing VSCSI access to LUNs
第9题:
0
1
255
256
第10题:
0
1
255
256
第11题:
Reboot AIX within the LPAR.
Run cfgmgr against the device sys0.
Shutdown and then activate the default_profile.
Ensure the RSCT daemon is operative and run cfgmgr again.
第12题:
Enable SMT
Reduce the weight
Renice the process
Increase the weight
第13题:
Companycom has just installed a p5 595 with four uncapped LPARs in a shared processor pool. The system and profile settings are still in their default states. One of the LPARs has an application that is consuming all of the available shared processor resources. Users of this application are complaining about response time. Which of the following changes to the slow LPAR would improve response time?()
第14题:
Companycom is using shared processor LPARs exclusively, including the Virtual IO Server. The users are complaining about response time. The application LPARs can be heavy processor users. The Virtual IO Server has been measured to be processor constrained. How should the Virtual IO Server's shared processor LPAR be configured?()
第15题:
The System Administrator has set up shared processors on three partitions in the p5 590 system. The shared processors have been set to uncapped. The system administrator notices that the logical partition is acting like it is capped. What is the most probable cause?()
第16题:
Companycom is planning a p5 595 running AIX 5L 5.3 LPARs. They would like to design the system using physical resources with maximum resource efficiency. One LPAR requires a peak load of 30 processors during the week with a low of 1 processor required on the weekend. The other LPAR requires only a single processor most of the time, but needs at least 24 processors at the beginning of the weekend to finish its weekly processing in the window allocated. Which of the following solutions is most appropriate to continuously maximize resource use for these two LPARs?()
第17题:
SLES9:2 dedicated processors AIX: 2.0 processing units,4 virtual processors,uncapped
SLES9:2.0 processing units,2 virtual processors,uncapped AIX:2.0 processing units,4 virtual processors,capped
SLES9:2.0 processing units,3 virtual processors,uncapped AIX:2 dedicated processors SLES9:2.5 processing units,3 virtual processors,capped
AIX:1.5 processing units,2 virtual processors,capped
第18题:
'pc' refers to the number of physical processors consumed, while 'ec' refers to the percentage of entitled capacity consumed.
'pc' refers to the 'physical CPUs' and lists how many are left un-allocated, while ec' refers to the 'entitled CPUs' and lists what amount is currently allocated to the LPAR.
'pc' refers to the 'processor count' and reflects how many CPUs are allocated to the LPAR, while 'ec ' refers to the 'extra capacity' and lists how much above the LPAR entitlement is being consumed.
'pc' refers to 'processor cards' and reflects how many MCM modules are actually being used by this LPAR, while 'ec' refers to the 'entitled CPUs'and lists what amount is currently allocated to the LPAR.
第19题:
8 desired processing units and 8 desired virtual processors
2 desired processing units and 8 desired virtual processors
8 desired processing units and 32 desired virtual processors
2 desired processing units and 32 desired virtual processors
第20题:
Capped and with a lower share
Uncapped and with a lower share
Uncapped and with a higher share
Capped and with no change in share
第21题:
All LPARs will start except LPAR5.
All LPARs will start with desired capacity.
All LPARs will start but LPAR5 will have its minimum capacity assigned.
All LPARs will start but LPAR5 will have less than its desired capacity.
第22题:
2
3
1.0
2.9
第23题:
Dynamic LPAR
Workload Manager
Partition Load Manager
Shared Processor Pools
第24题:
In the HMC Properties, select the options to allow processor sharing when the partition is inactive and active.
In the LPAR Properties, select the options to allow processor sharing when the partition is inactive and active.
In the LPAR Profile Properties, select the options to allow processor sharing when the partition is inactive and active.
In the 595 Managed System Properties, select the options to allow processor sharing when partitions are inactive and active.