On a diesel engine equipped with a hydraulic speed control governor, hunting in many cases can be corrected by adjusting the______.
A.accumulator spring compression
B.balance piston
C.compensating(补偿) needle valve
D.proportional piston
第1题:
One of the factors limiting the amount of toad which can be put on a modem marine diesel engine is the_______.
A.governor sensitivity
B.exhaust temperature
C.fuel injection pressure
D.speed of the cam shaft
第2题:
have a larger than normal dead band
produce excessive speed response to a load change
respond slowly to any change in engine load
stabilize engine speed at the new governor setting
第3题:
regulating the speed of the turbocharger
rotating the fuel injector pump plunger
regulating the speed of the fuel oil transfer pump
changing engine timing
第4题:
moving the governor control to stop
shutting off the lubricating oil supply
tripping the governor emergency stop lever
shutting off the fuel supply
第5题:
in such cases, the air supply is no longer optimal, the thermal load will be higher
governor hunting will occur
torsional vibrations as other mechanical vibrations may occur
all of the above are correct
第6题:
increase the governor oil pressure
adjust the speed droop setting
adjust the speeder spring travel
adjust the compensating needle valve
第7题:
smoky exhaust
starting failure
ignition relay
over speed
第8题:
accumulator spring compressor
balance piston
compensating needle valve
proportional piston
第9题:
controller
governor
instrument
apparatus
第10题:
react with insufficient speed droop
fail to react to small speed changes
have excessive sensitivity to small speed changes
remain in the neutral position
第11题:
speed will drop drastically with any increase in load
will stop due to zero fuel supply
will stall upon application of load
speed will remain fairly constant despite load changes
第12题:
motor
pump
governor
capstan
第13题:
Which of the following problems should be taken when cleaning the air filter on a diesel engine equipped with a turbocharger? .
A.Reduce engine speed to idle before removing the filter
B.Soak the dirty filter in kerosene only
C.Blow out the air inlet with compressed air
D.Cover the air inlet after removing the filter
第14题:
maximum power at a normal load
maximum power and load under normal conditions
half speed and normal temperature
normal operating temperature without a load
第15题:
compensate for low oil level
increase governor promptness
prevent governor hunting
limit engine load
第16题:
Disconnect the battery cables from the starting motor
Drain the hydraulic fluid from the governor sump
Block the flow of cooling air to the radiator
Secure the fuel supply and block the air intake
第17题:
speed limiting governor
variable speed governor
constant speed governor
load limiting governor
第18题:
adjusts the idle speed control
drain and flushes the governor and replace the oil
adjusts the compensating needle valve
第19题:
increase
decrease
fluctuate
remain constant
第20题:
Reduce engine speed to idle before removing the filter
Soak the dirty filter in kerosene only
Blow out the air inlet with compressed air
Cover the air inlet after removing the filter
第21题:
decrease only
increase only
decrease slightly then returned to original speed
increase slightly then returned to original speed
第22题:
speed droop
compensation
idle speed setting
load limit control
第23题:
torque limiter
over-speed trip
over-speed governor
load limit governor