A.TGCP里分别设置Frame relay或PPP
B.ILCP里分别设置Frame relay或PPP
C.都不是
第1题:
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc
第2题:
A.show frame-relay end-to-end
B.show frame-relay map
C.show frame-relay lmi
D.show frame-relay pvc
第3题:
A.错误
B.正确
第4题:
IP backhaul9224基站,在更换背板时,需要update btseqp表,输入新背板的()。
第5题:
A new frame-relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?()
第6题:
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?()
第7题:
基站IP backhaul方式时,在()数据表里要定义基站的背板系列号。
第8题:
IP backhaul基站信令必须通过5ESS作半固定连接。()
第9题:
Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?()
第10题:
You are implementing a new frame relay network to provide connectivity between you offices. To do this, you set up the frame relay network using point-to-point subinterfaces.Which of the following does NOT need to be configured?()
第11题:
cdmeqp或btseqp
cell2
cmodeqp
都不是
第12题:
第13题:
A. The local DLCI on each subinterface of the Frame Relay.
B. The Frame Relay encapsulation on the physical interface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point
第14题:
A.UMC下输入mlpppShow
B.LIU下输入mlpppShow
C.OMP上运行mlpppShow
D.AP上运行mlpppShow
第15题:
在“frame-relay map ip192.168.0.1100”这条命令中192.168.0.1和100指的是对端路由器的IP地址和DLCI。
第16题:
Which two statements are correct about configuring AutoQoS on a Cisco router? ()
第17题:
What does FRTP stand for?()
第18题:
在配置了帧中继本地DLCI和对端IP地址的映射后,使用什么命令来校验配置?()
第19题:
IP backhaul方式和Frame relay方式,基站背板参数主要区别在()。
第20题:
IP backhaul时,以下()方式可以了解基站分配到的IP地址。
第21题:
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()
第22题:
TGCP里分别设置Frame relay或PPP
ILCP里分别设置Frame relay或PPP
都不是
第23题:
The local DLCI on each subinterface of the Frame Relay.
The Frame Relay encapsulation on the physical interface.
An IP address on the physical interface.
The subinterface type as point-to-point