A.VTP
B.802.1q
C.IGP
D.ISL
E.802.3u
第1题:
If the OSPF protocol is used to connect customer edge (CE) routers to service provider edge(PE) routers in the VPN backbone, which two options best describe the use of SHAM links?()
第2题:
Which one of the WAN data-link protocols below is used for out-of-band signaling?()
第3题:
When a new trunk link is configured on an IOS based switch, which VLANs are allowed over the link()。
第4题:
Which two statements are correct regarding Flex Links? ()
第5题:
What are two enhancements that OSPFv3 supports over OSPFv2? ()
第6题:
When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link()。
第7题:
In which two environments would intra-partition parallelism be used? ()
第8题:
It requires the use of ARP.
It can support multiple IPv6 subnets on a single link.
It supports up to 2 instances of OSPFv3 over a common link.
It routes over links rather than over networks.
第9题:
LCP is used for basic PPP link setup and operation.
LCP is used for PPP CHAP authentication.
LCP is used for PPP over ATM (PPPoA) setup.
LCP is used for PPP over Ethernet (PPPoE) setup.
LCP is used for PPP over Frame Relay (PPPoFR) setup
第10题:
Routers maintain a single link-state database per area.
Routers maintain a separate Level 1 link-state database.
Routers maintain a separate Level 2 link-state database.
Routers maintain a single Level 1 link-state database per area.
第11题:
no VLANs
all VLANs
only VLANs 1 - 64
only the VLANs that are specified when creating the trunk
第12题:
to provide a mechanism to dynamically assign vlan membership to switch ports
to allow traffic to be carried from multiple vlans over a single link between switches
to allow native vlan information to be carried over a trunk link
to provide a mechanism to manually assign vlan membership to switch ports
to allow for managing the additions,deletions,and changes of vlans between switchs
第13题:
Virtual PortChannels (vPCs) allow links that are physically connected to two different Cisco switches to appear to a third downstream device as coming from a single device and as part of a single port channel. Which of the following are components of a Virtual PortChannel system? ()
第14题:
Which two statements are correct regarding IS-IS?()
第15题:
Which two link protocols are used to carry multiple VLANs over a single link?()
第16题:
Which statement about the Link Control Protocol (LCP) is true?()
第17题:
Which two routing protocols support MPLS traffic engineering link information distribution? ()
第18题:
What is the purpose of the cisco Vlan Trunking protocol?()
第19题:
show ospf database
show ospf neighbor
show protocols ospf
show ospf link-state
第20题:
The access link needs to be configured in multiple VLANs.
The link between the switches is configured in the wrong VLAN.
The link between the switches needs to be configured as a trunk.
VTP is not configured to carry VLAN information between the switches.
Switch IP addresses must be configured in order for traffic to be forwarded between the switches
第21题:
HDLC
NCP
PAP
LAPD
LAPB
None of the above
第22题:
Two peer devices: the vPC peers of which one is primary and one is secondary and are part of a vPC domain.
A Layer 3 Gigabit Ethernet link called peer-keepalive link to resolve dual-active scenarios
A redundant 10 Gigabit Ethernet PortChannel called a peer link to carry traffic from one system to the other when needed
vPC member ports forming the PortChannel
A dot1q trunk between the vPC peers
A management port that can be used as peer-keepalive link to resolve dual-active scenarios.
第23题:
OSPF
BGP
RIP version 2
IS-IS
EIGRP