Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been ask ed to review the implementation plan for this project. Which statement about the plan is

Refer to the exhi bit. ROUTE.com is planning to implement load balancing for traffic between host on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project. Which statement about the plan is true?（）

A. It is complete as written.

B. It should include a task to configure multipath to equal a value of 2 on R1 and R4.

C. It should use a ping instead of a traceroute to validate that load balancing has been activated.

D. It should conta in a task that documents the changes made to the configurations.

A. traffic - share balanced

B. distance

C. maximum- paths

D. default - network

E. variance

Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）

A. 1

B. 2

C. 3

D. 4

E. 5

A. Only traffic with a destination from 10.10.0.0/19 will be permitted.

B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.

C. Only traffic going to 10.10.0.0/19 will be permitted.

D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.

A.Traffic will be dropped per line 30 of the ACL.

B.Traffic will be accepted per line 40 of the ACL.

C.Traffic will be dropped, because of the implicit deny all at the end of the ACL.

D.Traffic will be accepted, because the source address is not covered by the ACL.

A. Use ping and the show ip route command to confirm the timers for each default network resets to 0.

B. Load balancing does not occur over default networks; the second route will only be used for failover.

C. Use an extended ping al ong with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.

D. Use the traceroute command to an address that is not explicitly in the routing table.

Refer to the exhibit. A client has asked you to consult on an eBGP loading question. Currently the AS 100 eBGP links have an average outbound load of 65% and 20% respectively. On further investigation, traffic from 10.10.24.0 accounts for 45%, and 10.10.25.0 and 10.10.32.0 accounts for 20% each of the outbound load. The customer wants to spread the load between the two eBGP links more evenly. The BGP attributes are currently set at their default values. If you are located at AS 100 and want to influence how AS 100 sends traffic to AS 200, what BGP attribute could you configure to cause AS 100 outbound traffic to load the eB GP links more evenly? （）

A. On router A, set the default local - preference to 50.

B. On router B, set the default metric to 150.

C. On router B, configure a route map for 10.10.25.0/24 with a local preference of 150 linked to neighbor 192.168.30.2.

D. On router B, set the default local -preference to 150.

Refer to the exhibit. You are the network administrator of the Route.com company. You have been tasked to implement a hub and spoke EIGRP topology over Frame Relay to provide connectivity between the networks at headquarters and all 300 spokes. Before you begin the actual implementation, which three pieces of information are more important to know than the others?（）

A. the Committed Information Rate of all the Frame Relay PVCs

B. the Cisco IOS version running on all the routers

C. the router model number of all the spoke routers

D. the number of HQ networks connected behind the headquarter routers

E. the routing policy, such as whether or not the spokes can be used as backup transient point between the two headquarter routers

A. Implement highly redundant switching and links with no single points or paths of failure.

B. Implement server load balancing.

C. Implement the Hot Standby Router Protocol (HSRP) for failover protection.

D. Implement intrusion detection with automatic notification of intrusion attempts in place.

A.No configuration file was found in NVRAM.

B.No configuration file was found in flash.

C.No configuration file was found in the PCMCIA card.

D.Configuration file is normal and will load in 15 seconds.