A. using aggregate routes
B. defining routes via the network statement
C. disablin g synchronization
D. forcing the next - hop address
第1题:
A. Has a maximum hop count of 25
B. Can differentiate between internal and external routes
C. Uses a 32-bit metric
D. Can maintain only one routing table
E. Need all networks to use the same subnet mask
F. Supports only one routed protocol
第2题:
Which two of the following are valid characteristics of EIGRP?()
第3题:
Which two statements describe the default routing policy for BGP?()
第4题:
Which two are default preference values for both internal and external IS-IS Level 2 routes on a Juniper Networks router?()
第5题:
BGP Routes with which community will not advertise to any peers?
第6题:
LDP is primarily used in internal networks of MPLS-VPN providers.
MP-BGP is used for label distribution for VPN customer routes.
Directed LDP is used for label distribution in L2-VPN Attachement Circuits.
MP-BGP is used for label distribution in MPLS Traffic Engineered networks.
第7题:
OSPF internal routes have a lower preference than static routes.
Both direct and local routes have the same preference value.
OSPF's preference value is lower than BGP.
OSPF has a single preference value for both internal and external routes.
第8题:
redistribute direct
redistribute static
redistribute connected
redistribute access-internal
第9题:
OSPF has a single preference value for both internal and external routes.
RIP is preferred over OSPF external routes.
Direct, local, and static routes have the same preference value.
OSPF's preference value is lower than BGP (both IBGP and EBGP).
第10题:
10
15
18
150
160
165
第11题:
RADIUS
KERBEROS
LDAP
TACACS+
第12题:
redistribute direct
redistribute static
redistribute connected
redistribute access-internal
第13题:
What technique should be used on BGP edge routers to prevent a multi - homed autonomous system from becoming a trans it system?()
第14题:
Which of the following routing protocols are unable to advertise CIDR networks?() (Select TWO)
第15题:
Which two are default preference values for both internal and external IS-IS Level 2 routes on a Juniper Networks router?()
第16题:
Which two options does Cisco PfR use to control the entrance link selection with inbound optimization?()
第17题:
Which two methods advertise internal networks to external ISPs via BGP?()
第18题:
Advertise with a high MED value all networks that are discovered via external BGP.
Set the no - export community attribute on all networks that are advertised externally.
Remove the AS - Path information on all routes in the BGP table pr ior to advertising externally.
Set the origin code to incomplete for all networks that are discovered via external BGP.
Only advertise networks externally if they have been discovered via internal BGP.
Use an outgoing distribution list to filte r all networks not originating from inside the autonomous system.
第19题:
OSPF
RIP
EIGRP
IGRP
RIPv2
第20题:
EBGP peers advertise MED and change Next Hop.
EBGP peers advertise Local Preference and do NOT change Next Hop.
Confederation BGP peers advertise MED and do NOT change Next Hop.
Confederation BGP peers advertise Local Preference and change Next Hop.
第21题:
15
18
150
165
第22题:
RIP is preferred over OSPF external routes.
Direct, local, and static routes have the same preference value.
OSPF's preference value is lower than BGP.
OSPF has a single preference value for both internal and external routes.
第23题:
Has a maximum hop count of 25
Can differentiate between internal and external routes
Uses a 32-bit metric
Can maintain only one routing table
Need all networks to use the same subnet mask
Supports only one routed protocol