A.采用口令"cisco"来保护控制台端口
B.通过将可用的线路数指定为0来拒绝用户访问控制台端口
C.通过提供所需的口令来访问线路配置模式
D.配置用于远程访问的特权执行口令
第1题:
A. RouterTK(config-line)# access-class 10 in
B. RouterTK(config-if)# ip access-class 23 out
C. RouterTK(config-line)# access-list 150 in
D. RouterTK(config-if)# ip access-list 128 out
E. RouterTK(config-line)# access-group 15 out
F. RouterTK(config-if)# ip access-group 110 in
第2题:
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
A. Switch1(config)# i nterface fa0 /1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
B. Switch1 (config)#interface fa0/1 Switch1 (config-if)# switchport mode trunk
C. Switch 1 (config)# i nterface fa0 /1 Switch1 (config-if)# duplex full Switch1 (config-if)# speed 100
D. Switch1 (config-if)# default-gateway 192.168.24.1
E. Switch1 (config)# line con 0 Switch1(config-line)# password cisco Switch1 (config-line)#login
第3题:
【单选题】输入以下命令的作用是什么? R1(config)# line vty 0 4 R1(config-line)# password check123 R1(config-line)# login
A.确保在进入用户执行模式之前输入口令
B.设置通过 Telnet 连接该路由器时使用的口令
C.要求在保存配置前输入 check123
D.创建本地用户帐户以便登录路由器或交换机
第4题:
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.What command would assign this access- list to the Virtual Terminal Lines?()
A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in
第5题:
A. ACCESS1(config)# line console 0 ACCESS1(config-line)# password cisco
B. Remote27(config)# line console 0 Remote27(config-line)# login Remote27(config-line)# password cisco
C. ACCESS1(config)# line vty 0 4 ACCESS1(config-line)# login ACCESS1(config-line)# password cisco
D. Remote27(config)# line vty 0 4 Remote27(config-line)# login Remote27(config-line)# password cisco
E. ACCESS1(config)# enable password cisco
F. Remote27(config)# enable password cisco