A.As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.
B.Remote access management of this switch will not be possible without configuration change.
C.More VLANs will need to be created for this switch.
D.The switch will need a different IOS code in order to support VLANs and STP.
第1题:
A. redundant
B. spanned
C. provisioned
D. converged
第2题:
A.Switch3, port fa0/1
B.Switch3, port fa0/12
C.Switch4, port fa0/11
D.Switch4, port fa0/2
E.Switch3, port Gi0/1
F.Switch3, port Gi0/2
第3题:
A.It has more than one interface that is connected to the root network segment.
B.It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C.It has a higher MAC address than the elected root bridge.
D.It has a higher bridge ID than the elected root bridge.
第4题:
A.Switch3
B.Switch4
C.Switch2
D.Switch1
第5题:
Which statement correctly describes network security settings in Cisco Network Assistant for the Catalyst Express 500 Switch?()
第6题:
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? ()
第7题:
Which term describes a spanning-tree network that has all switch ports in either the blocking or forwarding state?()
第8题:
Which one of the statements below correctly describes the Virtual Router Redundancy Protocol (VRRP), which is being used in the Company network to provide redundancy?()
第9题:
As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.
Remote access management of this switch will not be possible without configuration change.
More VLANs will need to be created for this switch.
The switch will need a different IOS code in order to support VLANs and STP.
第10题:
All switch and bridge ports are in the forwarding state.
All switch and bridge ports are assigned as either root or designated ports.
All switch and bridge ports are in either the forwarding or blocking state.
All switch and bridge ports are either blocking or looping.
第11题:
IGMP snooping is not active for VLAN 120 because the IGMP feature has not been enabled on the switch with the feature igmp command.
The IGMP snooping querier for VLAN 120 is not in a running state because the Loopback interface configured with 1.1.1.1/32 is currently in a down state.
IGMP snooping has been disabled on the VLAN 120 SVI.
IGMP snooping has been disabled for VLAN 120 in VLAN configuration mode.
IGMP snooping is not active for VLAN 120 because VLAN 120 does not exist in the VLAN database.
第12题:
Layer 2 switching and Layer 3 routing are mutually supported.
The port will not be associated with any VLAN.
The routed switch port supports VLAN subinterfaces.
The routed switch port is used when a switch has only one port per VLAN or subnet.
The routed switch port ensures that STP remains in the forwarding state.
第13题:
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?()
A.VLANs have not been created yet
B.An IP address must be configured for the port
C.The port is currently configured for access mode
D.The correct encapsulation type has not been configured
E.The no shutdown command has not been entered for the port
第14题:
A.Switch1
B.Switch2
C.Switch3
D.Switch4
第15题:
A.Switch A ,because it has the lowest MAC address
B.Switch C,because it has the lowest priority
C.Switch B,because it has the highest MAC address
D.Switch C,because it is the most centrally located switch
E.Switch A,because it is the most centrally located switch
F.Switch D,because it has the highest priority
第16题:
Which term describes a spanning-tree network that has all switch ports in either the blocking or forwardingstate? ()
第17题:
Which two of the following statements describe a routed switch port on a multilayer switch?()
第18题:
Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?()
第19题:
Which statement best describes what is depicted in the show command output?()
第20题:
Switch3, port fa0/1
Switch3, port fa0/12
Switch4, port fa0/11
Switch4, port fa0/2
Switch3, port Gi0/1
Switch3, port Gi0/2
第21题:
Effectively the trust boundary has been moved to the IP phone.
The host is now establishing the CoS value and has effectively become the trust boundary.
The switch is rewriting packets it receives from the IP phone and determining the CoS value.
The switch will no longer tag incoming voice packets and will trust the distribution layer switch to set theCoS
RTP will be used to negotiate a CoS value based upon bandwidth utilization on the link.
第22题:
A VRRP group has one active and one or more standby virtual routers.
A VRRP group has one master and one or more backup virtual routers.
A VRRP group has one master and one redundant virtual router.
None of the other alternatives apply
第23题:
The LOW setting enables broadcast storm control, but has no effect on the number of devices that can connect to a switch port
The LOW setting enables broadcast storm control and limits the number of devices that can connect to a switch port.
The LOW setting disables broadcast storm control but limits the number of devices that can connect to a switch port
The default network setting is HIGH