niusouti.com

What are two characteristics of SLB router mode?()A. The design supports multiple server subnets.B. An end-user sees the IP address of the real server.C. SLB routes between the outside and inside subnets.D. The source or destination MAC address is rewritt

题目
What are two characteristics of SLB router mode?()

A. The design supports multiple server subnets.

B. An end-user sees the IP address of the real server.

C. SLB routes between the outside and inside subnets.

D. The source or destination MAC address is rewritten, but the IP addresses left alone.

E. SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices.

相似考题

1.What will cause a Ezonexam router to enter setup mode? (Choose two)A. The configuration file is missing in NVRAM.B. The configuration register is set to 0x2100.C. Boot system commands are misconfigured in the running-configuration.D. The setup command was issued from the privileged mode prompt.E. The IOS is missing.F. The IOS is corrupt.

2.Which two characteristics are true of a firewall running in routed mode based on the following information?()A. FWSM routes traffic between the VLANs.B. FWSM switches traffic between the VLANs.C. Routed mode is often called bump-in-the-wire mode.D. Routed mode firewall deployments are used most often in current designs.

3.A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?()A. The IOS image will be ignored.B. The router will prompt to enter initial configuration mode.C. The router will boot to ROM.D. Any configuration entries in NVRAM will be ignored.E. The configuration in flash memory will be booted.

4.What are two instances when a WX device route carves? ()(Choose two.)A. It occurs every 29 hours.B. Packet interception mode is enabled.C. The host is unreachable on the local subnet.D. The subnet is unreachable using the advertised router.

更多“What are two characteristics of SLB router mode?() ”相关问题

  • 第1题：

    Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()

    A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.

    B.Router1 is acting as a TFTP server for other routers.

    C.Router1 cannot locate a valid IOS image in flash memory.

    D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.

    E.Cisco routers will first attempt to load a image from TFTP for management purposes.


    参考答案：A, C

  • 第2题：

    What are two characteristics of Telnet (Choose two.)()。

    A.Itsendsdataincleartextformat.

    B.ItisnolongersupportedonCisconetworkdevices.

    C.ItismoresecurethanSSH

    D.Itrequiresanenterpriselicenseinordertobeimplemented.

    E.ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.


    参考答案：A, E

  • 第3题：

    What are two characteristics of Server Load Balancing router mode？（）

    • A、 The design supports multiple server subnets Cisco 642-874： Practice Exam
    • B、 An end-user sees the IP address of the real server
    • C、 SLB routes between the outside and inside subnets
    • D、 The source or destination MAC address is rewritten， but the IP addresses left alone
    • E、 SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices

    正确答案:A,D

  • 第4题：

    A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?（）

    • A、The IOS image will be ignored.
    • B、The router will prompt to enter initial configuration mode.
    • C、The router will boot to ROM.
    • D、Any configuration entries in NVRAM will be ignored.
    • E、The configuration in flash memory will be booted.

    正确答案:B,D

  • 第5题：

    As an experienced technician， you are responsible for Technical Support. Which of the followingdescriptions is correct about the characteristic of SLB one arm mode？（）

    • A、 This out-of-band approach supports scaling
    • B、 SLB· is not inline.
    • C、 Mode is not as common as bridge or routed mode.
    • D、 Return traffic requires PB·R， server default gateway pointing to SLB·， or client source NAT·

    正确答案:C

  • 第6题：

    What are two instances when a WX device route carves? （）(Choose two.)

    • A、It occurs every 29 hours.
    • B、Packet interception mode is enabled.
    • C、The host is unreachable on the local subnet.
    • D、The subnet is unreachable using the advertised router.

    正确答案:C,D

  • 第7题：

    What are two characteristics of OER？ （）

    • A、 It can take on HSRP， VRRP， and GLBP as clients.
    • B、 It provides automatic inbound route optimization.
    • C、 Path selection may be based on delay， loss， or jitter.
    • D、 The border router makes decisions about which outbound path to use.
    • E、 Automatic load distribution is provided for multiple connections.

    正确答案:C,E

  • 第8题：

    多选题
    What are two characteristics of SLB router mode?（）
    A

    The design supports multiple server subnets.

    B

    An end-user sees the IP address of the real server.

    C

    SLB routes between the outside and inside subnets.

    D

    The source or destination MAC address is rewritten, but the IP addresses left alone.

    E

    SLB acts as a bump in the wire between servers and upstream firewall or Layer 3 devices.


    正确答案： D,C
    解析： 暂无解析

  • 第9题：

    多选题
    What are two characteristics of the SLB One-arm mode？ （）
    A

    It is not as common as bridge mode

    B

    The MSFC is not directly connected to the CSM

    C

    Outbound traffic from servers may need to be directed by PBR or CSNAT to the CSM

    D

    The SLB is moved to a position where selected inbound and outbound server traffic goesthrough the SLB

    E

    The CSM statically routes inbound server traffic to the aggregation switch FWSM， then to the connected server subnet


    正确答案： B,A
    解析： 暂无解析

  • 第10题：

    多选题
    What are two characteristics of OER? （）
    A

    It can take on HSRP, VRRP, and GLBP as clients.

    B

    It provides automatic inbound route optimization.

    C

    Path selection may be based on delay, loss, or jitter.

    D

    The border router makes decisions about which outbound path to use.

    E

    Automatic load distribution is provided for multiple connections.


    正确答案： A,D
    解析： 暂无解析

  • 第11题：

    单选题
    As an experienced technician， you are responsible for Technical Support. Which of the followingdescriptions is correct about the characteristic of SLB one arm mode？（）
    A

     This out-of-band approach supports scaling

    B

     SLB· is not inline.

    C

     Mode is not as common as bridge or routed mode.

    D

     Return traffic requires PB·R， server default gateway pointing to SLB·， or client source NAT·


    正确答案： A
    解析： 暂无解析

  • 第12题：

    多选题
    A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?（）
    A

    The IOS image will be ignored.

    B

    The router will prompt to enter initial configuration mode.

    C

    The router will boot to ROM.

    D

    Any configuration entries in NVRAM will be ignored.

    E

    The configuration in flash memory will be booted.


    正确答案： B,C
    解析： 暂无解析

  • 第13题：

    What are two characteristics of a switch that is configured as a VTP client?()

    A.if a switch that is configured to operate in client mode cannot access a VTP server,then the switch reverts to transparent mode.

    B.The local vlan configuration is updated only when an update that has a higher configuration revision number is received.

    C.Vtp advertisements are not forwarded to neighboring switches that are configured in vtp transparent mode.

    D.When switches in vtp client mode are rebooted,they send a vtp advertisement request to the vtp servers.

    E.Vtp client is the default vtp mode

    F.On switches that are configured to operate in client mode ,vlans can be created,deleted,or renamed locally


    参考答案：B, D

  • 第14题：

    What are two characteristics of Telnet (Choose two.)（）。

    • A、Itsendsdataincleartextformat.
    • B、ItisnolongersupportedonCisconetworkdevices.
    • C、ItismoresecurethanSSH
    • D、Itrequiresanenterpriselicenseinordertobeimplemented.
    • E、ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.

    正确答案:A,E

  • 第15题：

    What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）

    • A、To restart the router.
    • B、To bypass the configuration in Flash.
    • C、To view the password before changes are made.
    • D、To bypass setup configuration mode.
    • E、To access ROM Monitor mode.

    正确答案:E

  • 第16题：

    What are two characteristics of the SLB One-arm mode？ （）

    • A、 It is not as common as bridge mode
    • B、 The MSFC is not directly connected to the CSM
    • C、 Outbound traffic from servers may need to be directed by PBR or CSNAT to the CSM
    • D、 The SLB is moved to a position where selected inbound and outbound server traffic goesthrough the SLB
    • E、 The CSM statically routes inbound server traffic to the aggregation switch FWSM， then to the connected server subnet

    正确答案:A,C

  • 第17题：

    what will happen if u configure two router as NTP server （something like that）.


    正确答案:The router will choose the best reliable server and will synchronise with it.

  • 第18题：

    You have a Bridged 1483 service offering where each ATM PVC is assigned a /30 subnet. What are two characteristics of this configuration？（）

    • A、It burns IP addresses.
    • B、It conserves IP addresses.
    • C、Both the client and the ERX Edge Router have IP addresses.
    • D、The client has an IP address， but the ERX Edge Router uses an unnumbered address.

    正确答案:A,C

  • 第19题：

    What are two characteristics of SLB router mode?（）

    • A、The design supports multiple server subnets.
    • B、An end-user sees the IP address of the real server.
    • C、SLB routes between the outside and inside subnets.
    • D、The source or destination MAC address is rewritten, but the IP addresses left alone.
    • E、SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices.

    正确答案:A,C

  • 第20题：

    多选题
    What are two characteristics of Server Load Balancing router mode？（）
    A

    The design supports multiple server subnets Cisco 642-874： Practice Exam

    B

    An end-user sees the IP address of the real server

    C

    SLB routes between the outside and inside subnets

    D

    The source or destination MAC address is rewritten， but the IP addresses left alone

    E

    SLB acts as a bump in the wire between servers and upstream firewall or Layer 3 devices


    正确答案： D,B
    解析： 暂无解析

  • 第21题：

    多选题
    What are two characteristics of a switch that is configured as a VTP client？（）
    A

    if a switch that is configured to operate in client mode cannot access a VTP server，then the switch reverts to transparent mode.

    B

    The local vlan configuration is updated only when an update that has a higher configuration revision number is received.

    C

    Vtp advertisements are not forwarded to neighboring switches that are configured in vtp transparent mode.

    D

    When switches in vtp client mode are rebooted，they send a vtp advertisement request to the vtp servers.

    E

    Vtp client is the default vtp mode

    F

    On switches that are configured to operate in client mode ，vlans can be created，deleted，or renamed locally


    正确答案： B,C
    解析： 暂无解析

  • 第22题：

    多选题
    You have a Bridged 1483 service offering where each ATM PVC is assigned a /30 subnet. What are two characteristics of this configuration？（）
    A

    It burns IP addresses.

    B

    It conserves IP addresses.

    C

    Both the client and the ERX Edge Router have IP addresses.

    D

    The client has an IP address， but the ERX Edge Router uses an unnumbered address.


    正确答案： A,D
    解析： 暂无解析

  • 第23题：

    多选题
    What are two instances when a WX device route carves? （）(Choose two.)
    A

    It occurs every 29 hours.

    B

    Packet interception mode is enabled.

    C

    The host is unreachable on the local subnet.

    D

    The subnet is unreachable using the advertised router.


    正确答案： D,A
    解析： 暂无解析

  • 第24题：

    多选题
    What are two characteristics of Telnet (Choose two.)（）。
    A

    Itsendsdataincleartextformat.

    B

    ItisnolongersupportedonCisconetworkdevices.

    C

    ItismoresecurethanSSH

    D

    Itrequiresanenterpriselicenseinordertobeimplemented.

    E

    ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.


    正确答案： D,C
    解析： 暂无解析

相关内容