Refer to the exhibit. The Route.com company is running EIGRP between all the r outers. Currently, if one of the LAN links (LAN1 or LAN2) at the headquarters flaps (goes up and down), the HQRTR1 and HQ - RTR2 routers will experience high CPU usage and have

Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verification plans for this OSPF project. Which statement about the plan is true? （）

A. It is complete as written

B. It should include a task that verifie s that the interarea routes are using the proper MED

C. It should include a task that verifies that load sharing is active on R1 and R4

D. It should include a task that verifies that all redundant links will become active when the primary links are sh ut down

Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been ask ed to review the implementation plan for this project. Which statement about the plan is true?（）

A. It is complete as written.

B. It should include a task to configure EIGRP multipath equal to 2 on R1 and R4.

C. It should inc lude a task to implement OSPF because it handles unequal cost load balancing most efficiently using variance.

D. It should include a task that establishes a baseline before and after the configuration has been changed.

Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP an d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals?（）

A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.

B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.

C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.

D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.

Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? （）

A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0

B. access - list 100 permit ip host 0.0.0.0 any

C. access - list 100 permit ip any host 0.0.0.0

D. A default -network cannot be redistributed between routing processes.

Refer to the exhibit. A Boston company bought th e assets of a New York company and is trying to route traffic between the two data networks using EIGRP. The show command output shows that traffic will not flow between the networks. As a network consultant, you were asked to modify the configuration a nd certify the interoperability of the two networks. For traffic to flow from subnet 172.16.8.0/24 to the 172.16.16.0/24 subnet, which configuration change do you recommend?（）

A. Turn off autosummarization on routers N1 and B1.

B. Add IP summary addre sses to the Internet - pointing interfaces of routers N1 and B1.

C. Turn off autosummarization on routers N2 and B2.

D. Add wildcard masks to the network commands on routers N2 and B2.

Refer to the exhibit.The actual speed of the serial links between R2 and R3 are 256 kb/s and 512k b/s respectively. When configuring EIGRP on routers R2 and R3, the network administrator configured the bandwidth of both serial interfaces to 512 kb/s. What will be the effect?（）

A. EIGRP will overutilize the 512 kb/s link.

B. The interface "delay" value used in the EIGRP metric calculation will be inaccurate on the 256k b/s serial interface.

C. The amount of bandwidth used for EIGRP routing protocol traffic on the 256 kb/s link can become excessive.

D. EIGRP can load balance between the two serial links only if the variance is set to 2 or higher.

E. Unequal cost load balancing will be disabled.

Refer to the exhibit. You are the network administrator of the Route.com company. You have been tasked to implement a hub and spoke EIGRP topology over Frame Relay to provide connectivity between the networks at headquarters and all 300 spokes. Before you begin the actual implementation, which three pieces of information are more important to know than the others?（）

A. the Committed Information Rate of all the Frame Relay PVCs

B. the Cisco IOS version running on all the routers

C. the router model number of all the spoke routers

D. the number of HQ networks connected behind the headquarter routers

E. the routing policy, such as whether or not the spokes can be used as backup transient point between the two headquarter routers

A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24

B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0

C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachable

D.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24

Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3?（）

A. 10.0.0.0/8

B. 172.16.10.0/24

C. 172.16.0.0/24

D. 10.10.10.0/24

E. 172.16.0.0/16

F. 10.10.0.0/16

A. FWSM routes traffic between the VLANs.

B. FWSM switches traffic between the VLANs.

C. Transparent mode is often called bump-in-the-wire mode.

D. Transparent mode firewall deployments are used most often in current designs.

E. Traffic routed between VLANs is subject to state tracking and other firewall configurable options.

Refer to the exhibit. ROUTE.com is planning to implement a new secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on th e 172.16.20./24 network. You have been asked to review the implementation plan for the OSPF project. Which statement about the plan is true?（）

A. It is complete as written.

B. It should include a task that shuts down all unused interfaces.

C. It sho uld include tasks that enable and verify OSPF authentication.

D. It should include a task that establishes a file transfer baseline before and after the configuration is changed.

Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?（）

A. The no auto - summary command needs to be added under router eigrp 1

B. The subnets keyword was not included in the redistribute command under router ospf 1

C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A

D. The default - information originate command needs to be added under router ospf 1

E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF

A. router rip

B. router eigrp 10

C. redistribute eigrp 10

D. redistribute rip

E. default - metric 10000 100 255 1 1500

F. default - metric 5

A. traffic - share balanced

B. distance

C. maximum- paths

D. default - network

E. variance

Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）

A. 1

B. 2

C. 3

D. 4

E. 5

Refer to the exhibit. When you examine the routing table of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing ta ble. You are also not able to see the R4 Ethernet subnet on the R1 routing table.Which configuration change should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configur ation command(s).（）

A. R1 and R4

B. R2 and R3

C. ip summary-address eigrp 1 10.1.1.0 255.255.255.0 and ip summary - address eigrp 110.2.2.0 255.255.255.0

D. variance 2

E. eigrp stub connected

F. no auto - summary

A. Both outgoing and incoming routing updates on R1 will be permitted because the d istribute - list 20 out Serial0/0 command cannot be used with association with the outgoing interface.

B. All incoming routing updates from R2 will be suppressed, but the outgoing updates will continue to be sent.

C. Both outgoing and incoming routing up dates on R1 will be stopped because of the passive - interface Serial0/0 configuration statement.

D. All outgoing routing updates from router R1 to router R2 will be suppressed, but the inbound updates will continue to be received.

A. The no auto - summary command has not been issued under the EIGRP process on both routers.

B. Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24.

C. EIGRP cannot exchange routing updates with a neighbor‘s router interface that is configured with tw o IP addresses.

D. EIGRP cannot form neighbor relationship and exchange routing updates with a secondary address.

A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1

B. R4(config)# ip default - network 10.0.0.0

C. R4(config - router)# default -information originate

D. R4(conf ig)# ip route 10.0.0.0 255.0.0.0 10.1.1.1

A.The path of the packets will be R3 to R2 to R1.

B.The path of the packets will be R3 to R1 to R2.

C.The path of the packets will be both R3 to R2 to R1 and R3 to R1.

D.The path of the packets will be R3 to R1