A. 10.1.1.2
B. 192.168.1.49
C. 10.1.1.1
D. 192.168.1.50
第1题:
A. ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1
B. network 10.10.10.0
C. no synchronization
D. neighbor 10.10.10.1 next - hop - self
第2题:
Observe the diagram. RTC is the hub router and RTA and RTB are the spokes. There are no virtual circuits between the spoke locations. What is needed to successfully route traffic to the 11.11.11.0/24 network from RTA? ()
A. The neighbor 10.10.10.1 next - hop - self com mand on RTA
B. Nothing is required. This is the default behavior on this topology
C. The neighbor 10.10.10.1 next - hop - self command on RTB
D. The neighbor 10.10.10.1 next - hop - self command on RTC
第3题:
During a recent OSPF election among three routers, RTA was elected the DR and RTB was elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place ofthe DR whi le RTC becomes the new BDR. What will happen when RTA comes back online?()
A. A new election will take place establishing an all new DR and BDR based on configured priority levels and MAC addresses.
B. RTA will take the place of DR immediately upon esta blishing its adjacencies.
C. RTA will take the place of DR only if RTB fails.
D. RTA will take the place of DR only if both RTB and RTC fail.
第4题:
A.the MAC address of the seiver network interface
B.the MAC address of host A
C.the MAC address of router interface e 1
D.the MAC address of router interface e0
第5题:
What is correct regarding the configuration shown below?() (1)static route 0.0.0.0/0 (2)qualified-next-hop 172.30.25.1 preference 7 (3)next-hop 172.30.25.5
第6题:
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
第7题:
Which two methods advertise internal networks to external ISPs via BGP?()
第8题:
During BGP configuration on a router that has peered with other BGP speakers, the BGP command aggregate-a ddress 172.32.0.0 255.255.252.0 is issued. However, the peers do not receive this aggregate network in BGP advertisements. Also, the router does not have this aggregate network in its BGP table. Which option indicates a possible reason this command did not cause the router to advertise the aggregate network to its peers?()
第9题:
What is the first step in BGP route selection?()
第10题:
The next hop is I2's BGP RID
The next hop is I2's IP address used on the R2 - I2 neigh bor relationship
The next hop is R2's BGP RID
The next hop is R2's IP address used on the R1 - R2 neighbor relationship
第11题:
The local router prefers the route with the shortest as-path.
The router first verifies that it has a route to the bgp Next Hop IP address.
The local router prefers the route from the peer with the lowest peer id address.
The local router prefers the route learned from an ebgp peer over a route learned from an ibgp peer.
第12题:
The local router prefers the route with the shortest AS Path.
The local router verifies that it has a route to the BGP Next Hop IP address.
The local router prefers the route from the peer with the lowest peer ID address.
The local router prefers the route learned from an EBGP peer over a route learned from an IBGP peer.
第13题:
Refer to the exhibit diagram and config uration. RTB is summarizing its networks from AS 64100 with the aggregate - address command. However, the show ip route command on RTA reveals the RTB individual networks as well as its summary route.Which option would ensure that only the summary route would appear in the routing table of RTA?()
A. Add a static route with a prefix of 192.168.24.0 255.255.252.0 pointing to the null0 interface.
B. Create a route map permitting only the summary address.
C. Delete the four network statements and leave onl y the aggregate - address statement in the BGP configuration.
D. Add the keyword summary - only to the aggregate - address command.
第14题:
A. RTA will not establish an OSPF adjacency w ith RTB
B. RTA will send OSPF hello packets, but will not send OSPF updates
C. RTA will not accept OSPF hello packets from RTB
D. RTA will send OSPF updates, but will not establish an adjacency with RTB
第15题:
Refer to the exhibit. Router RTA is the hub router for routers RTB and RTC. The Frame Relay network is configured with EIGRP, and the entire network is in autonomous system 1. However,router RTB a nd RTC are not receiving each other‘s routes. What is the solution?()
A.Check and change the access lists on router RTA
B.Configure the auto summary command under router eigrp 1 on router RTA
C.Configure subinterfaces on the spoke routers and assig n different IP address subnets for each subinterface
D.Issue the no ip split horizon command on router RTA
E.Issue the no ip split horizon eigrp 1 command on router RTA
F.Configure a distribute list on router RTA that allows it to advertise all r outes to the spoke routers
第16题:
A.The IP address for Server A is a broadcast address.
B.The IP address for Workstation B is a subnet address.
C.The gateway for Workstation B is not on the same subnet.
D.The gateway for Server A is not on the same subnet.
第17题:
Refer to the exhibit. Which rule does the DHCP server use when there is an IP address conflict?()
第18题:
A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network()。
第19题:
Which three statements about the BGP next-hop attribute are true? ()
第20题:
What is the first step in BGP route selection?()
第21题:
EBGP sessions between confederation sub ASs do not modify the next-hop attribute.
By default, iBGP sessions change the next-hop attribute learned from eBGP peers to self address.
By default, the next-hop attribute is not changed when a prefix is reflected by the route reflector
EBGP sessions between confederation sub ASs change the next-hop attribute to peer address.
By default, iBGP sessions preserve the next-hop attribute learned from eBGP peers.
第22题:
an OSPF update for network 192.168.0.0/16
a static router to network 192.168.10.0/24
a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
a RIP update for network 192.168.10.0/24
a directly connected interface with an address of 192.168.10.254/24
a default route with a next hop address of 192.168.10.1
第23题:
a directly connected interface with an address of 192.168.10.254/24
a static route to network 192.168.10.0/24
a RIP update for network 192.168.10.0/24
an OSPF update for network 192.168.0.0/16
a default route with a next hop address of 192.168.10.1
a static route to network 192.168.10.0/24 with a local serial interface configured as the next hop