After executing the "show host" command, which of the information below would you see?()
第1题:
You are a technician at TestKing. Your assistant applied an IP access control list to Router TK1. You want to check the placement and direction of the access control list.Which command should you use?()
A. show access-list
B. show ip access-list
C. show ip interface
D. show interface
E. show interface list
第2题:
A. Show ip protocols
B. Show ip route rip
C. Debug ip rip
D. Debug ip updates
E. Debug ip transactions
第3题:
You‘re the systems administrator at Testing, and you create the following access control lists.You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?()
A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10
第4题:
A.show ip access-list
B.show access-list
C.list ip interface
D.show interface
E.show ip interface
第5题:
只封禁一台地址为193.62.40.230主机的access-list的正确配置是
A.access-list 110 permit ip any any access-list 110 deny ip host 193.62.40.230 any access-list 110 deny ip any host 193.62.40.230
B.access-list 110 deny ip host 193.62.40.230any access-list 110 deny ip any host 193.62.40.230 access-list 110 permit ip any any
C.access-list 110 deny ip host 193.62.40.230 any access-list 110 deny ip any host 193.62.40.230
D.access-list 110 deny ip host 193.62.40.230 any access-list 110 permit ip any any access-list 110 deny ip any host 193.62.40.230
第6题:
Which profile configuration command dynamically creates a host route in the routing table?()
第7题:
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?()
第8题:
Which one of the following commands will display the placement and direction of an IP access control list on the interfaces of a router?()
第9题:
Which command is used to display the placement and direction of an IP access control list on a router?()
第10题:
As a network administrator, you have been instructed to prevent all traffic originating on the LAN from entering the R2 router. Which the following command would implement the access list on the interface of the R2 router?()
第11题:
router(config-line)# ip access-group 1 in
router(config-line)# access-class 1 in
router(config-line)# ip access-list 1 in
router(config-line)# access-line 1 in
第12题:
The IP addresses of workstations allowed gain access to the router via an access list
Permanent name-to-address mappings created using the ip host command.
Temporary and permanent DNS entries.
The names of the routers created using the hostname command.
The length of time of users logged into the router, as well as the duration
第13题:
A. show interface list
B. show ip route
C. show ip interface
D. show ip interface brief
E. show interface
第14题:
A. The IP addresses of workstations allowed gain access to the router via an access list
B. Permanent name-to-address mappings created using the ip host command.
C. Temporary and permanent DNS entries.
D. The names of the routers created using the hostname command.
E. The length of time of users logged into the router, as well as the duration
第15题:
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.What command would assign this access- list to the Virtual Terminal Lines?()
A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in
第16题:
The access control list shown in the graphic has been applied to the Ethernet interface of router R1using the ip access-group 101 in command.Which of the following Telnet sessions will be blocked by this ACL?()
A.from host PC1 to host 5.1.1.10
B.from host PC1 to host 5.1.3.10
C.from host PC2 to host 5.1.2.10
D.from host PC2 to host 5.1.3.8
第17题:
You are a technician at TestKing. Your assistant applied an IP access control list to Router TK1. You want to check the placement and direction of the access control list.Which command should you use?()
第18题:
In a PPP over ATM service offering,which command inserts the user's host route into the routing table?()
第19题:
Which command shows if an access list is assigned to an interface?()
第20题:
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines. What command would assign this access- list to the Virtual Terminal Lines?()
第21题:
While logged into a router, you wish to see the RIP routing updates in real time as they are sent and received. Which command would you issue to see these updates?()
第22题:
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
第23题:
show ip access-list
show access-list
list ip interface
show interface
show ip interface